Current Revision Page

Under Review

Looking to see if there is a way that globally in a project you can make a certain revision the current page rather than clicking on each page to make a certain revision current. I'm finding I have to go back to a previous revision to print takeoff, I have my revision changes in different layers so I can make the takeoff current for any given layer, but if that revision is not the current drawing the takeoff values are 0. I would also need the option there to move takeoff when doing this so the takeoff goes with the drawing. Hopefully this makes sense.

Lorin Allred zzTakeoff9h 13m

Thank you for the feature request! As far as I know, you have to go through each page to switch the revision.

We have been discussing some form of a "sub-project" where you could switch the "sub-project" for each revision. That was mostly planned for the different design stages like 25%, 50%, 90%, etc, but it could tie into this.

You must be logged in to post replies. If you don't have an account you can signup here.