Am i doing something wrong?

Completed

So my Linear are in Meter. I'm trying to calculating the studs at X mm cts. I've click the cog and change it to measure as mm as per the below. But in the Formula the mm is note getting brought over so its still Linear/600 equalling 0.04 Number . Is setting the mm from the setting just a visual thing and everything need to be treated as Meters

Heber Allred zzTakeoff89d 8h

Hi Brendon. Does it work right if you use this formula?

[Linear:mm] / [Stud Spacing]

Note: the "mm" on the variable property is mostly for when it's displayed in legends, reports, etc. then it will show these units. It doesn't impact the formula calculation currently.

Brendon R 89d 8h

Thanks that worked

👍1

You must be logged in to post replies. If you don't have an account you can signup here.