Dimension Measures of [Length] and [Width] results in the area Takeoff for Rectangles (Box Mode)

Under Review

Currently, for Rectangle Area takeoffs, the primary output displayed in reports and the "Measurements" list is the total Area (SF). While the Area is essential, for example, for balcony and deck construction (And I assume a few other use case...), the Length and Width are equally critical primary measurements for manufacturing/purchasing

It owuld be amazing if when a takeoff is created using the Rectangle Tool, the specific Length and Width dimensions be treated as standard "Result" fields that appear in the Measurement List and Exported Reports.

Geoff Van Brunt 5d 4h

I second this. Really helpful for doing siding. You can do the siding measuement with with area and with height and width you can calculate starter strips, j channel etc. Along with all required fasteners.

Of course this would only work with a rectangular takeoff

You must be logged in to post replies. If you don't have an account you can signup here.