Ortho set to only 90 degree angles?

Is there a way to set the set / edit the Ortho to only move in 90 degree increments? We do a lot of interior work and with the angles being so small it generally means a lot of zooming in to get the correct snap points. Would be much easier if they were only set to 90 degrees.

👍1

Stephen Daves zzTakeoff135d 20h

Hi, we do not have a way to ONLY use 90 degree angles, but with Ortho on, you will see it lock to each 45 degree angle, allowing you to choose 90 degree angles.

👍1

You must be logged in to post replies. If you don't have an account you can signup here.