I deal with this sort of problem with drywall/insulation/framing all the time where the assembly is the same but their may be changes in ceiling, deck or floor height. Currently I would just create...

Further to Nicholas's point for the ACT ceilings/grid ceiling if we could retrieve the linear footage of the perimeter for wall molding that would be beneficial There are also some programs that al...

If you can also find a way to make it more TAB friendly that would be awesome. I can't check it right now but if I remember correctly the drop downs in the forms cause some issues when trying to ta...

Segment length between points on linear tool would be extremely helpful. You could build a formula to optimize lumber/drywall/trim ordering. I tried building somthing similar in planswift but was u...

This is a good example of what I'm requesting. This is a takeoff on a normal house that I just did. I have everything grouped by assembly_name>Takeoff>Item Name. As you can see for some assemblies ...

The takeoff would still have the height property. So as you go through each floor and perform your takeoff you would still populate the takeoff with floor height. Using the same imaginary 7 floor e...