Hey Luke, I duplicate that page and then set the scale for each page separately to do takeoffs only in the area for the given scale of that page.

If I interpret what you want to do correctly, then highlight all the takeoff items you want to copy in your Takeoff Tab and select Ctrl+C. Open the project you want to copy it to. In the Takeoff Ta...

I hope to see it soon. It is not just pricing that need easy batch edit. All the properties that make up a list item are subject to mass edit needs.

THIS is a huge issue I have been dealing with. Any chance you can share how to do this / set this up?

@Shawn M, so the red dot allows you to rotate a sheet to join sheets that do not have matchlines that are 0, 90, 180, etc?

Hey Shane, I usually duplicate the page and perform takeoffs with scale "A," then do takeoffs on the duplicate page at scale "B." For clarity, I drop a note on those pages so it is quickly obvious ...

@ Rick, I have similar interests as your initial post. While this does not address everything you ask for, this helps me organize reports by adding a "Sequence #" property to everything in my produ...

@Todd I would attend this Zoom call, if permitted. The weekly Zoom calls are missed!

The "one tool way" - full steam ahead ZZ!

Back to top please. Dashed lines would be immediately valuable. Ex:Single phase electric = single dashDouble phase electric = double dashTriple phase electric = triple dash Additional line type:Dot...

Pages can become cluttered with takeoffs, so I often duplicate pages to separate different division takeoffs. Is there a way to duplicate a group of already stitched pages?

Ortho angle request for pipe bend angles 11.25 & 22.5 degrees. I would definitely want to the ability to turn these on/off as I would only need them in specific circumstances. Getting those exact ...

Search / Create Count Takeoffs: Finding items and assigning a takeoff is good. Better would be the capability to select a takeoff (and all sub-assembly parts) from a template. For example, if I se...

I stitched together 7 pages and that worked well. Except now Zoom to Fit only zooms to my initial page size and manually zooming out zooms a little further out but not all the way to show all 7 pag...

Hi Jeff, I use product lists heavily to build my templates (part assemblies) with. I do not put any costing into ZZ, that is not due to any issue with ZZ. We have an internal system where all costi...

https://www.zztakeoff.com/app/community/feature-requests/community-enhancement-bookmarks

An additional point of clarity, there are bend deviations (arcs) in some long pipe runs but the circumstances I am interested in would occur at angles between straight lines.

@ Thomas - My new background!!!

+1 for symbol recognition. Electrical site infrastructure symbols such as Primary Pull Box, Transformer, 3 Phase Sector Pad, etc. would be very valuable.

@AnonymousOne - I agree! I would need the ability to "fine tune" page alignments since match lines are frequently wrong.

Further detail on my use case, stitching together a Colorized image is great for transparency to ensure accurate alignment. While Opaque can be difficult to align, because it blocks an image out, i...