Ditto Mark, I run into this daily with a municipal electrical sheet that was "snipped" from a civil sheet, then marked up by hand with no scale, no dimensions, etc. A three-point match & scale wou...

Todd, please email me the Dev Mode Knowledge Base link.

Hi Lorin! Rather than create folders and manually drag projects to them, for sorting and organizing projects is there a plan to add properties or options for custom properties at the time of creat...

*Sequence # Tip: Initially setup your sequence # 's to skip 5 or 10 numbers making space for future product items to be inserted without editing the entire list. Ex:1.000001.000051.00010 If the ski...

Hi Jon, I created a sequence # property for every product list item and assigned a sequence # that meets our report "sequence order" requirements. It's a bit tedious to setup but saves a lot of tim...

Hey Luke, I duplicate that page and then set the scale for each page separately to do takeoffs only in the area for the given scale of that page.

If I interpret what you want to do correctly, then highlight all the takeoff items you want to copy in your Takeoff Tab and select Ctrl+C. Open the project you want to copy it to. In the Takeoff Ta...

I hope to see it soon. It is not just pricing that need easy batch edit. All the properties that make up a list item are subject to mass edit needs.

THIS is a huge issue I have been dealing with. Any chance you can share how to do this / set this up?

@Shawn M, so the red dot allows you to rotate a sheet to join sheets that do not have matchlines that are 0, 90, 180, etc?

Hey Shane, I usually duplicate the page and perform takeoffs with scale "A," then do takeoffs on the duplicate page at scale "B." For clarity, I drop a note on those pages so it is quickly obvious ...

@ Rick, I have similar interests as your initial post. While this does not address everything you ask for, this helps me organize reports by adding a "Sequence #" property to everything in my produ...

@Todd I would attend this Zoom call, if permitted. The weekly Zoom calls are missed!

The "one tool way" - full steam ahead ZZ!

Back to top please. Dashed lines would be immediately valuable. Ex:Single phase electric = single dashDouble phase electric = double dashTriple phase electric = triple dash Additional line type:Dot...

Pages can become cluttered with takeoffs, so I often duplicate pages to separate different division takeoffs. Is there a way to duplicate a group of already stitched pages?

Ortho angle request for pipe bend angles 11.25 & 22.5 degrees. I would definitely want to the ability to turn these on/off as I would only need them in specific circumstances. Getting those exact ...

Search / Create Count Takeoffs: Finding items and assigning a takeoff is good. Better would be the capability to select a takeoff (and all sub-assembly parts) from a template. For example, if I se...

I stitched together 7 pages and that worked well. Except now Zoom to Fit only zooms to my initial page size and manually zooming out zooms a little further out but not all the way to show all 7 pag...

Hi Jeff, I use product lists heavily to build my templates (part assemblies) with. I do not put any costing into ZZ, that is not due to any issue with ZZ. We have an internal system where all costi...

https://www.zztakeoff.com/app/community/feature-requests/community-enhancement-bookmarks

An additional point of clarity, there are bend deviations (arcs) in some long pipe runs but the circumstances I am interested in would occur at angles between straight lines.

@ Thomas - My new background!!!

+1 for symbol recognition. Electrical site infrastructure symbols such as Primary Pull Box, Transformer, 3 Phase Sector Pad, etc. would be very valuable.

@AnonymousOne - I agree! I would need the ability to "fine tune" page alignments since match lines are frequently wrong.