Q & A

I'm sure this has been covered or is not coming to me intuitively but can someone direct me to how to sort (alphanumeric) drawing sheets?

Good afternoon, This mainly comes into play for asphalt and site concrete take-offs in my experience, is there a feature to quickly add an "ar...

When using the cutout tool the cursor and entire screen has extreme lag making it all but unusable. It's exclusively happening only when the cut o...

Is there a way enter a length while using the area or linear takeoff tool and give it a specific direction in the X/Y axis plane with degrees? (si...

I'm pretty sure I was able to export to excel and all of the levels would export, now I only am able to export 1 level, I cannot export the detail...

So my Linear are in Meter. I'm trying to calculating the studs at X mm cts. I've click the cog and change it to measure as mm as per the below. ...

Just wondering if there's been any thought in using an AI agent, (hopefully Claude) in the Work Flow, namely just being able to Start a new job an...

This is a pretty minor thing, but I'm wondering if there is a setting that allows us to change the "State" label to match the nomenclature of our ...

I'm not sure if I'm missing something, but I can't seem to lock cutouts within an area takeoff. I use area takeoffs on reflected ceiling plans to...

Please allow fine adjustments and movements of takeoff to be done using the up, down, left, right arrows on the keyboard (in conjunction with usin...

Once complete, can you change the layer in which a take-off item is on?

I love the hyperlinks! Anyway to be able to right click and open them as a separate sheet?

Is there a formula to get the project name into reports? In PS I think it was something like [\Job\Name]

Is there a setting to control the line width when printing to PDF? The printed line widths are quite distorted and do not match the takeoff line w...

Can I turn a legend on en mass after I finish my estimations. I find the legend adds too much culture during the estimation process, but I li...

Hi A handy item would be show labels as you could in plan swift. Especialy for area take offs that way you can label different area with area an...

Is there a way to turn the cross hairs off on the cursor? Would love this option.

Hello, I was wondering if you guys were able to take a request. I wanted to ask if it was possible for us to be to move section and rearrange ...

Any chance you guys delve into more than estimating with your software and go more granular for design? Similar to Mitek, Eagle Metal, Paragon, etc.

Hello, I am building an assembly for formwork for a vertical curb, and I created 5 options to build a curb which is a 2x4 all the way to a 2x1...